Motor Controller Design Update

So, it took me much less than anticipated to figure out how Eagle works. I was thinking it would take me the whole summer, but it only took 2 days. I downloaded the free version from their website and got cracking right away. I found an awesome tutorial on Youtube that walked me through the basics, and then I got the hang of it.

I did a little research on how I can actually get the PCB manufactured, and it turns out it is not so cheap. As you would expect, the price goes up as the board gets larger. Therefore, I tried to keep my design as minimal as possible. My original plan was to have the "big" MOSFETs (I explained what I meant by big in my last post) laid horizontally so I can use some large copper plates on the board as heat sinks. The MOSFETs I am using come in TO-220 packaging which means you can mount them to heatsinks since they come with a big area of expose metal in the back. Here is a picture of TO-220 packaging (source: Wikipedia).

However, I had to ditch that idea because the boards became too big for me to be able to afford. I am going to use oshpark.com's service to get the board manufactured and they charge $5 per square inch for a 2-layer board. However, they do give you three copies of your board for that price. Anyways, here is a screenshot from Eagle of how the PCB currently looks like. 

I actually really like oshpark's website. It looks really simple and it is very easy to use. To get a quick quote and to get your design verified, all you have to do is upload your Eagle PCB design files. Then they automatically process it online and give pictures of how your board is going to look like when it is printed. My board is going to be 2-layers, and its dimensions are 3.44x1.5 inches. This is going to cost me a tad over $25 for 3 copies. Check out the OSH Park renderings below. 

Board Top

Board Bottom

Top Layer

Bottom Layer

You might spot weird connections on the board. This is only my first time, and it turns out routing wires on 2-layer boards is very tricky. This is probably the design that is going to be manufactured. I go back to the design files every once in a while and try to spot any mistakes. But because the transistors will be vertical rather than horizontal, there won't be any heatsinks on them. This means that I can't pull more than a couple of Amps continuously (hopefully). Trying to pull more than that will cause the transistors to overheat.

Let me know what you guys think!

Anil